Certikin Swimming Pool Counter Current Unit

Certikin Swimming Pool Counter Current Unit

The Certikin Swimming Pool Counter Current Unit is specially designed with small pools in mind to give you a new way to enjoy your pool and exercise at the same time. Installing a Certikin Counter Current unit in your pool enables you to swim as far as you like without the need for turning around.

The Counter Current system is equiped with a 3HP Certikin pump to provide a constant stream of water which enables you to swim on the spot. The current flow is adjustable so swimmers of all abilites can swim at their own pace as long as they like in your own pool.

A directional outlet on the Certikin Counter Current Unit allows a 15 degree inclination in any direction and also featuers an adjustable air/water mixer for a relaxing bubble massage effect.

What's Included with the Certikin Swimming Pool Counter Current Unit:

• Faceplate assembly and housing with jet
• On / off controls
• 3 HP pump (1 or 3 phase) with connection accessories (2x elbows, 2x valves - pipework not included)
• Control box to activate the pump via faceplate controls
• Air suction connection 20mm diameter with air button and flexible pipe
• Directional inlet 41mm diameter which provides water and air regulation and up to 15 degrees movement

Installation of your Certikin Counter Current Unit

The counter current unit housing should be installed during swimming pool construction. The Certikin swimming pool counter current unit can be purchased in component form as follows:

1. Faceplate assembly and housing
2. Pump kit
3. Control box

Only the Counter Current unit Faceplate assembly and housing is required at pool construction phase this enables pool construction at relatively low cost and allows full installation of the system at a later date if required. The pump should be installed as close as possible to the pool for maximum performance (within wiring regulations).

Please note that to order a full Certikin swimming pool counter current system a Faceplate Assembly, Pump Kit and corresponding Electrical Control Box need to be ordered.

Technical Specifications:

Flow Qmax:

40 m³/h

Pump capacity:

3HP

Electrical requirements:

220v or 380v

Water return connection:

90mm diameter

Water impulsion connection:

75mm diameter

Air tube connection:

20mm diameter

Adjustable jet:

41mm diameter

Max. angle jet adjustment:

15 degrees